What To Know
- A malfunctioning drain pump can be a major inconvenience, leaving you with a sink full of dirty dishes and a dishwasher that won’t drain.
- It works by using a motor to spin an impeller, which creates a suction that pulls the water out of the dishwasher and into the drain hose.
- If the drain pump doesn’t run or if water doesn’t flow out of the drain hose, the drain pump is faulty and needs to be replaced.
A malfunctioning drain pump can be a major inconvenience, leaving you with a sink full of dirty dishes and a dishwasher that won’t drain. If you’re experiencing this issue with your Kenmore dishwasher, don’t despair. With a little troubleshooting, you can easily test the drain pump and determine if it needs to be replaced.
How Does a Dishwasher Drain Pump Work?
The drain pump is responsible for removing water from the dishwasher after the wash cycle is complete. It works by using a motor to spin an impeller, which creates a suction that pulls the water out of the dishwasher and into the drain hose.
Signs of a Faulty Dishwasher Drain Pump
There are a few signs that may indicate a faulty dishwasher drain pump:
- The dishwasher doesn’t drain at all.
- The dishwasher drains slowly.
- The dishwasher makes a loud noise when draining.
- The dishwasher leaks water from the bottom.
How to Test a Kenmore Dishwasher Drain Pump
If you’re experiencing any of the above signs, you can test the drain pump to see if it’s faulty. Here’s how:
1. Unplug the dishwasher from the power outlet.
2. Open the dishwasher door.
3. Locate the drain pump. The drain pump is usually located at the bottom of the dishwasher, near the back. It’s a small, round device with a motor and an impeller.
4. Disconnect the drain hose from the drain pump.
5. Place a bucket or pan under the drain hose.
6. Turn on the dishwasher.
7. Observe the drain pump. The drain pump should start running and water should start flowing out of the drain hose.
8. If the drain pump doesn’t run or if water doesn‘t flow out of the drain hose, the drain pump is faulty and needs to be replaced.
Replacing a Kenmore Dishwasher Drain Pump
If you need to replace the drain pump in your Kenmore dishwasher, you can follow these steps:
1. Purchase a new drain pump. You can purchase a new drain pump online or at a local appliance store. Make sure to get a drain pump that is compatible with your Kenmore dishwasher model.
2. Unplug the dishwasher from the power outlet.
3. Open the dishwasher door.
4. Locate the drain pump. The drain pump is usually located at the bottom of the dishwasher, near the back. It’s a small, round device with a motor and an impeller.
5. Disconnect the drain hose from the drain pump.
6. Remove the old drain pump. There are usually a few screws that hold the drain pump in place. Remove the screws and lift the drain pump out of the dishwasher.
7. Install the new drain pump. Place the new drain pump in the dishwasher and secure it with the screws.
8. Reconnect the drain hose to the drain pump.
9. Plug the dishwasher back into the power outlet.
10. Turn on the dishwasher and test it.
Conclusion: Troubleshooting Your Kenmore Dishwasher Drain Pump
If you’re experiencing problems with your Kenmore dishwasher drain pump, you can easily test it and replace it if necessary. By following the steps outlined in this article, you can get your dishwasher up and running again in no time.
