What To Know
- Replacing the inlet valve is a relatively simple repair that can be completed in about an hour with the right tools and materials.
- Reconnect the dishwasher to the water supply by turning on the valve under the sink or by turning on the main water supply to your home.
- Replacing the inlet valve on a Whirlpool dishwasher is a relatively simple repair that can be completed in about an hour with the right tools and materials.
A faulty inlet valve can cause a variety of problems with your Whirlpool dishwasher, including leaking, not filling with water, or not washing dishes properly. Replacing the inlet valve is a relatively simple repair that can be completed in about an hour with the right tools and materials.
Tools and Materials Needed:
- New Whirlpool dishwasher inlet valve
- Adjustable wrench
- Phillips head screwdriver
- Flat head screwdriver
- Pliers
- Bucket
- Rags
- Flashlight
Step-by-Step Guide:
1. Turn Off the Water Supply:
Before you begin, turn off the water supply to your dishwasher. This is typically done by closing the valve under the sink or by turning off the main water supply to your home.
2. Disconnect the Dishwasher:
Disconnect the dishwasher from the power supply by unplugging it or turning off the circuit breaker. Then, move the dishwasher away from the cabinets so that you have enough room to work.
3. Remove the Old Inlet Valve:
Locate the inlet valve, which is typically found on the bottom of the dishwasher, near the back. Use the adjustable wrench to loosen the nuts that hold the inlet valve in place. Once the nuts are loose, you can remove the old inlet valve by pulling it straight out of the dishwasher.
4. Clean the Inlet Valve Area:
Use the rags to clean the area where the old inlet valve was located. This will help to ensure that the new inlet valve fits properly and does not leak.
5. Install the New Inlet Valve:
Insert the new inlet valve into the dishwasher. Make sure that the valve is properly aligned and that the gasket is in place. Then, use the adjustable wrench to tighten the nuts that hold the inlet valve in place.
6. Reconnect the Dishwasher:
Reconnect the dishwasher to the water supply by turning on the valve under the sink or by turning on the main water supply to your home. Then, plug the dishwasher back in or turn on the circuit breaker.
7. Test the Dishwasher:
Run the dishwasher through a short cycle to test the new inlet valve. Make sure that the dishwasher fills with water, washes the dishes properly, and drains properly.
Troubleshooting:
If you are having problems with your Whirlpool dishwasher after replacing the inlet valve, here are a few things to check:
- Make sure that the new inlet valve is properly installed and that the gasket is in place.
- Make sure that the water supply is turned on and that the dishwasher is getting enough water.
- Check the drain hose to make sure that it is not clogged.
- If the dishwasher is still not working properly, you may need to call a qualified appliance repair technician.
Conclusion:
Replacing the inlet valve on a Whirlpool dishwasher is a relatively simple repair that can be completed in about an hour with the right tools and materials. By following the steps in this guide, you can save yourself the cost of calling a repair technician.
