What To Know
- The drain hose is located at the bottom of the dishwasher.
- The water inlet hose is located at the top of the dishwasher.
- Run a cycle with a few dishes to make sure the dishwasher is working properly.
Dishwashers are an essential part of any modern kitchen, and when they break down, it can be a major inconvenience. If you’re facing a broken Frigidaire dishwasher, don’t despair. With a little time and effort, you can put it back together and get it running again.
Tools and Materials
Before you start, you’ll need to gather a few tools and materials:
- Phillips head screwdriver
- Flat head screwdriver
- Pliers
- Adjustable wrench
- New dishwasher door gasket (if needed)
- New dishwasher drain hose (if needed)
- New dishwasher water inlet hose (if needed)
Step-by-Step Instructions
1. Turn off the water supply to the dishwasher. This is usually done by turning off the valve under the sink.
2. Disconnect the dishwasher from the power supply. This is done by unplugging the dishwasher or turning off the circuit breaker that powers it.
3. Remove the dishwasher door. To do this, open the door and locate the screws that hold it in place. Remove the screws and carefully lift the door off the dishwasher.
4. Remove the dishwasher drain hose. The drain hose is located at the bottom of the dishwasher. Disconnect it from the drain pipe and pull it out of the dishwasher.
5. Remove the dishwasher water inlet hose. The water inlet hose is located at the top of the dishwasher. Disconnect it from the water supply and pull it out of the dishwasher.
6. Remove the dishwasher door gasket. The door gasket is located around the edge of the dishwasher door. Carefully pry it off with a flat head screwdriver.
7. Inspect the dishwasher for damage. Look for any cracks, dents, or other damage. If you find any damage, you’ll need to replace the damaged part.
8. Clean the dishwasher. Use a damp cloth to wipe down the inside and outside of the dishwasher. Remove any food particles or debris.
9. Install the new dishwasher door gasket. If you’re replacing the door gasket, apply a thin bead of silicone sealant around the edge of the door. Then, press the new gasket into place.
10. Reattach the dishwasher door. Line up the door with the hinges and insert the screws. Tighten the screws until the door is secure.
11. Reattach the dishwasher drain hose. Connect the drain hose to the drain pipe and tighten the clamp.
12. Reattach the dishwasher water inlet hose. Connect the water inlet hose to the water supply and tighten the clamp.
13. Turn on the water supply to the dishwasher.
14. Turn on the power to the dishwasher.
15. Test the dishwasher. Run a cycle with a few dishes to make sure the dishwasher is working properly.
Troubleshooting
If you’re having trouble putting your Frigidaire dishwasher back together, here are a few things to check:
- Make sure that you’ve reconnected all of the hoses and wires properly.
- If the dishwasher is leaking, check the door gasket for damage.
- If the dishwasher is not draining properly, check the drain hose for clogs.
- If the dishwasher is not filling with water, check the water inlet hose for clogs.
Conclusion: DIY Dishwasher Repair
With a little time and effort, you can put your Frigidaire dishwasher back together and get it running again. If you’re not comfortable working on appliances, you can always call a qualified repair technician. However, if you’re up for the challenge, DIY dishwasher repair can save you a lot of money.
